Majacraft Suzie Professional Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Roda Berputar Majacraft Suzie Professional. Majacraft Suzie Professional 12 halaman.
Juga untuk Majacraft Suzie Professional: Manual (12 halaman)

Halaman Cetak

4. Spinning Head

Required:

1 M6x60mm Gold JCB (2 1/2") bolt (in the handle

assembly)

4mm allen T-wrench

1 Wood spacer tube (in the handle assembly)

Spinning Head

The spinning head can be raised or lowered to suit

the tensioning of the drive belt and the height at

which you wish to spin.

5. Pulley

Required:

1 - Pulley

2mm allen T-wrench

The M6 60mm bolt and wood spacer are attached

to the handle. You must remove it first. Take the

spinning head and slide it down into the handle.

Push the JCB bolt in a little way through the hole

in the top of the handle. Align the wooden spacer

tube in the handle so the bolt will can be pushed

through the centre.

Screw the JCB bolt into place without tightening it

fully. Position the head near the top of the handle

and then tighten the JCB bolt firmly. There is no

need to over-tighten this.

majacraft