Aguilar AG 500SC-212C Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Aguilar AG 500SC-212C. Aguilar AG 500SC-212C 7 halaman.

Pull Series

signal path.

When this knob is pushed in the Effects Loop is configured in

"parallel" and you can mix your "dry" signal with the signal from

the Effects Loop. When this knob is pulled out the Effects Loop is

configured in "series" and all of your signal will pass through the

Effects Loop. If you do not have anything plugged into the Effects

Loop pulling this knob will cut off your signal completely.

D.I. Section

D.I. Nominal Output Level: -20dBu

Pre/Post

D.I.

Lift/Ground

a ground loop. In many cases pushing in the

can fix this problem.

B. Rear Panel Features

Speaker Outputs: Two Speakon outputs and two ¼" outputs are

provided. Any combination may be used as long as the load does not

exceed 4 ohms.

Tuner Output: One ¼" Tuner output is provided. When the amplifier is

muted your signal will still reach the tuner.

: Removes any "dry" (un-effected) signal from the

Button:

Pre

- Your signal goes to the D.I. XLR output jack before

Gain

your

and EQ settings, but after the

–10dB

input pad.

Post

Gain

Master

, EQ,

the D.I. XLR output jack.

: If there is a hum when using the D.I. there may be

settings and effects will be sent to

Lift/Ground

button