IKEA IHW7243VS0 Panduan Penggunaan dan Perawatan - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Kap Ventilasi IKEA IHW7243VS0. IKEA IHW7243VS0 32 halaman. 24" (61.0 cm) - 30" (76.2 cm) wall-mount canopy range hood
Halaman Cetak
Charcoal Filter- ForNon-Vented (recirculating)
Installations
The charcoal filter is not washable nor reusable.
They should be changed every 4 months in normal use.
The charcoal filter captures unpleasant cooking odors.
To Install Charcoal
Filters
1. Turn blower and lights off. Check that halogen lamp is cool.
2. Remove the front panel by extracting them outward.
3. Remove the metal grease filter by pushing handle toward the
rear and pull downward.
4. Remove the grease filter.
5. Install charcoal filter over grille on blower housing and align
the pins (B) on the cowl with the slots (C), then turn the filter
clockwise until it locks in place.
B
A
\
B
J
C
C
A. Blower housing
B. Pins
C. Slots
6. Repeat to install other charcoal filter.
To Replace Charcoal
Filters
1. Turn blower and lights off. Check that halogen lamp is cool.
2. Remove the front panel by extracting them outward.
3. Remove the metal grease filter by pushing handle toward the
rear and pull downward.
4. Pull filter toward front and set aside.
5. Turn charcoal filter counterclockwise.
6. Remove and discard charcoal filter.
7. Repeat to remove other charcoal filter.
8. Install replacement charcoal filter over grille in blower housing
and align the pins (B) on the cowl with the slots (C) (see
illustration for Step 6 in "To Install Charcoal Filters"), then turn
the filter clockwise.
9. Repeat Step 9 to install other charcoal filter.
Replacing
a Halogen
Lamp
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect
power.
2. Use a flat-blade screwdriver and gently pry the light cover
loose.
3. Remove the lamp and replace with a 12-volt, 20-watt
maximum, halogen lamp made for a G-4 base.
4. Replace the light cover.
13