Airgo ProCare IC Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Kursi roda Airgo ProCare IC. Airgo ProCare IC 12 halaman.

Halaman Cetak

AdJUSTING THE WHEEL LOCKS

1. Ensure the wheel-lock is in the open (unlocked) position.

2. Loosen the bolt & locknut that secure the wheel-lock to the

wheelchair frame.

3. Adjust the position of wheel-lock until the measurement between the rear

wheel and the wheellock shoe is between 1/4 and 13/32 inches.

4. Securely tighten the bolt & locknut.

5. Engage the wheel-lock and push against the wheelchair to determine if

wheel-lock engages the wheel-lock shoe enough to hold the wheelchair.

6. Repeat the above procedures until the wheel-lock holds the wheelchair.

PULL TO LOCK

UNLOCKED

POSITION

BOLT & LOCKNUT

WHEEL-LOCK

HANDLE

WHEEL-LOCK

SHOE

1/4" - 13/32"

(6.4 - 10.3 mm)

TO REMOVE DETACHABLE DESK ARMS (IF APPLICABLE)

1. Push in the button lock at the front base of the arm.

2. Lift the arm up and off.

TO REPLACE DETACHABLE DESK ARMS (IF APPLICABLE)

1. Reposition the arms.

2. The button lock will automatically snap in place.

ChANGING SEAT-TO-FLOOR HEIGHT

1. Remove the rear wheels from the wheelchair and reinstall

LOCKED

POSITION

2. Remove the front casters from the wheelchair and reinstall

If applicable, adjust anti-tippers according to new seat-to-floor height.

SIDE

FRAME

TOP

BOTTOM

8" WHEEL

TOP

FRONT FORK

MIDDLE

(AXLE POSITION)

BOTTOM

to desired height.

LOCKNUT

M12

to desired height.

FRONT FORK

LOCKNUT

SPACER

24" REAR WHEEL

(AXLE POSITION)

HUB CAP

HEX BOLT

M12 X 110 MM

BOLT