Alien green Mostat Petunjuk Untuk Manual Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Untuk Manual Instalasi untuk Termostat Alien green Mostat. Alien green Mostat 15 halaman.

When the room sensor is all set up, make sure that

control block (PCB) are permanently ON, without blinking.

Only when

AP-Status

and

A GUIDE TO OCCATIONAL PROBLEMS AND HOW TO SOLVE THEM

AP-Status light is blinking: This signals that the process control block (PCB) cannot connect to your home

Wi-Fi router. In this case, the process control block (PCB) must be restored to its factory state.

How to Perform a Factory Reset on the Process Control Block (PCB):

block (PCB) for 10 seconds until the

this way the device will be factory reset. Open the application on your mobile phone, choose "

and follow the instructions on your phone.

How to Perform a Factory Reset on the Room Sensor:

the red light starts. Let the button go – and the blue light will start blinking. This way the device will be factory reset.

Open the application on your mobile phone, choose "

How to Reset Password on Wi-Fi Router:

must be

factory reset

Status

lights are permanently ON, close the central heating boiler and switch it on.

AP-Status

and

In case of resetting the password, the process control block (PCB)

AP-Status

and

Status

lights on process

Hold down the button on process control

Status

lights start blinking fast. Then let the button go – and

Hold down the room sensor button for 10 seconds until

Configuration

" and follow the instructions on your phone.

Configuration