Align-Pilates Ladder Barrel Mk II Manual Petunjuk Perakitan - Halaman 3
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Peralatan Kebugaran Align-Pilates Ladder Barrel Mk II. Align-Pilates Ladder Barrel Mk II 8 halaman.
4. Assembly Instructions
Take out the side panels and lay on a soft surface so as not to scratch the wood. Attach the side
panels to the barrel top using x 3 medium bolts with Loctite washers and nut, ensure a washer is
used on each side - the nut goes on the inside of the barrel (Fig. 1 & Fig. 2). Do not fully tighten the
nuts as this will prevent you being able to insert the barrel connecting poles later in the assembly.
Insert the x2 short barrel connecting poles into the holes of the side panels. Use x 4 medium bolts
and washers and screw these in until hand tight (x 2 on each side) (Fig. 3). You can now tighten the
x6 medium bolt, washer and nut attaching the side panels to the barrel top.
Next, attach the black metal runners. Place the runners on the inside of the barrel with the side with
4 holes next to the wooden panel. It will become obvious which runner is for which side. First use
the x 2 long bolts (use a washer on both sides) and thread them through from the outside of the
barrel and do the nuts up hand tight.
Then screw in the remaining x 2 medium bolts + washers, then tighten all bolts and repeat for the
other side – see Fig 4 & Fig 5 below.
Fig.1
3
Fig. 2
Fig. 3