Alirac ECL-160 Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem Pengelasan Alirac ECL-160. Alirac ECL-160 16 halaman.

generated while welding.

* It is should be equipped in the open air where there is no direct sunlight, anti-rain,

temperature range from -10℃ to +40℃ and low humidity place.

* 50cm space is needed to ensure good ventilation.

* No metal impurities are tolerant inside the welder.

* In some areas, there is no severe vibration.

* Make sure no interference will be caused to the surrounding in the welding area.

* Whether the power supply capacity is sufficient to allow the welder to work

normally or not. And a safety protection device should be equipped in the input

power.

* Prevent it from dumping if the welder is put in the place of over 10°incline.

2.4 Security Check

The following items must be checked up by the operator each time before access to

the power source.

* Make sure the power socket is reliably grounded.

* Make sure the output terminals are well connected without short circuit.

* Make sure output and input cables are perfect with no exposure.

The welding machine must be inspected by professionals at regular time (not exceed 6

months). The contents as follow:

* Whether the electronic components are loosed or not and dust removal must be

conducted.

* Whether the panel mounted on the device should be able to guarantee the normal

implementation of the machine.

* Whether the input cables are damaged or not. If yes, safe handling must done.

Warning!

Disconnect the power source before servicing it. Contact with the manufacturer