Alirac HE115-125/950 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penggiling Alirac HE115-125/950. Alirac HE115-125/950 10 halaman.

Halaman Cetak

Angle Grinder

HE115-125/950

Rated Voltage

Input Power

No-load speed

Disc Dia

SAVE THESE INSTRUCTIONS

Work Area

1.keep you work area clean . Cluttered

benches and dark areas invite accidents.

2.Do not operate power tools in

explosive atmospheres, such as in the

presence of flammable liquids,gases, or dust

or fumes.

3.Keep

bystanders,children

visitors away while operating a power tool.

Distractions can cause you to lose control.

ELECTRICAL SAFETY

4.Power tools plugs must match the

outlet. Never modify the plugs in any way.

Do not use any adapter plugs with earthed

power tools. Unmodified plugs and matching

outlets will reduce risk of electric shock. Do

not change the plug in any way. Double

insulation eliminates the need for the three

wire grounded power cord and grounded

power supply system.

5.Avoid body contact with grounded

surface such as pipes, radiators, ranges and

refrigerators. This is an increased risk of

electric shock if your body is grounded.

6.Do not expose power tools to rain or

wet conditions. Water entering a power tool

will increase the risk of electric shock.

7.Do not abuse the cord. Never use

the cord to carry the tools or pull the plug

from an outlet. Keep cord away from heat,

oil, sharp edges or moving parts. Replace

damaged cords immediately. Damaged cord

220-240V~50/60HZ

950W

11500r/min

125mm

and

increase the risk of electric shock.

8.When operating a power tool outside,

use an outdoor extension cord marked "W-

A" or "W". These cords are rated for outdoor

use and reduce the risk of electric shock.

PERSONAL SAFETY

9.Stay alert, watch what you are doing

and use common sense when operating a

power tool. Do not use tool while tired or

under the influence of drugs, alcohol, or

medication. A moment of inattention while

operating power tools may result in serious

personal injury.

10.Dress properly. Do not wear loose

clothing or jewelry. Contain long hair. Keep

your hair, clothing, and gloves away from

moving parts. Loose clothes, jewelry, or long

hair can be caught in moving parts.

11.Avoid accidental starting. Be sure

switch is off before plugging in. Carrying

tools with your finger on the switch or

plugging in tools that have the switch on

invites accidents.

12.Remove adjusting keys or wrenches

before turning the tool on. A wrench or key

that is left attached to a rotating part of the

tool in unexpected situations.

13.Do not overreach. Keep proper

footing and balance at all times. Proper

footing and balance enables better control of

the tool in unexpected situations.

14.Use safety equipment. Always wear

eye protection. Dust mask, non-skid safety

shoes, hard hat, or hearing protection must

be used for appropriate conditions. Ordinary

eye or sun glasses are NOT eye protection.

TOOL USE AND CARE

15. Use clamps or other practical ways

to secure and support the workpiece to a

stable platform. Holding the work by hand

-1-