Garmin GNS 530 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Tampilan Avionik Garmin GNS 530. Garmin GNS 530 14 halaman. Supplement a21 to the airplane flight manual da 40 diamond com/nav/gps
Juga untuk Garmin GNS 530: Panduan Pilot (22 halaman), Petunjuk Manual (6 halaman), Adendum Panduan Pilot (27 halaman), Adendum Panduan Pilot (4 halaman), Referensi Cepat (16 halaman), Brosur (1 halaman), Referensi Cepat (23 halaman), Adendum Panduan Pilot (22 halaman), Manual (35 halaman)

Halaman Cetak

1.3.6

LOC Specifications (GNS 530 Only)

Regulatory Compliance

(TAWS units only)

Receiver Audio Sensitivity

Course Deviation Sensitivity

Flag

AGC Characteristics

Selectivity

Spurious Response

Centering Accuracy

Audio Output

Audio Response

Audio Distortion

500 SERIES INSTALLATION MANUAL

190-00181-02

TSO C36e, JTSO-C36e, RTCA DO-195 Class A, EuroCAE

ED-46B

Annex 10 Volume I (Radio Navigation Aids) Par. 3.1.4

ETSO-2C36f

At -103.5 dBm (S+N)/N shall not be less than 6 dB.

-103.5 dBm or less for 60% of standard deflection.

The LOC Course Deviation Flag must be flagged:

a) in the absence of an RF signal.

b) When either the 90 or 150 Hz modulating signals is

removed and the other is maintained at its normal 20%.

c) In the absence of both 90 and 150 Hz modulation.

d) When the level of a standard localizer deviation test

signal produces less than a 50% of standard deflection.

From -86 dBm and -33 dBm input of a Standard VOR Audio

Test Signal, audio output levels shall not vary more than 3

dB.

Nose Bandwidth: The input signal level required to produce

the reference AGC voltage shall not vary more than 6 dB

over the input signal frequency range of ± 9 kHz from the

assigned channel frequency.

Skirt Bandwidth: The input signal level required to produce

reference AGC voltage shall be at least 70 dB greater than

the level required to produce reference AGC voltage at the

assigned channel frequency at ± 36 kHz from the assigned

channel frequency.

Greater than 80 dB.

Typical 0 ± 3 mV (Max error 9.9 mV per RTCA DO-195).

A minimum 100 mW into a 500 Ω load.

Less than 6 dB of Variation between 350 and 2500 Hz.

Except the 1020 Hz Ident Tone is at least 20 dB down in

voice mode.

The distortion in the receiver audio output shall not exceed

10% at all levels up to 100 mW.

Page 1-5

Rev S