alkitronic EAF Panduan Pengoperasian dan Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Pompa Air alkitronic EAF. alkitronic EAF 16 halaman. Battery powered torque multiplier
Halaman Cetak
Operating and service manual
5.2 Direction of rotation, transport lock
Direction right (clock-
wise, tightening). Push
the slide switch com-
pletely to the left.
Direction left (counter-clockwise, loos-
ening). Push the slide switch completely
to the right.
Transport lock (start lock).
Push the slide switch to the
middle.
5.3 Gear change Type EAF (rapid mode / power mode)
Do not shift to 1st
or 2nd gear during
operation, otherwise
the changeover gear
will be damaged.
In order to optimize the bolt-
ing cycle it is recommended to
start in gear 2 (fast) and then,
depending on the required
torque switch to gear 1 (power gear) until the stopping point.
See also pos. 5.4 Setting the stopping torque.
Gear 2
Gear 1
5.4 Setting the shut-off torque
Setting the torque is done by means of the torque table on
the alkitronic® EAF or according to the Calibration certificate
included.
The machine-specific torque values are compiled
and documented by the alki TECHNIK calibration
lab and are enclosed with these operating and
maintenance instructions.
Torque table
Calibration certificate (sample)
In the torque table each position number is assigned a respec-
tive torque. The shut-off torque is set by means of the setting
wheel (SR) using the position number (1-11) (Fig. 1).
• The selection of the shut-off torque is done by means of
the setting wheel, with 11 settings per gear (values 1-11
according to torque table).
Position 12 (setting wheel, Fig 1) will provide the
full torque available for loosening bolts and nuts.
When the set torque value has been reached the tool
will switch off precisely and an acoustic signal (beep) is
sounded.
Preselection shut-off torque
Setting wheel with position num-
bers (arrow on tool case must
point to the required number)
SR
Fig. 1
8