All American Scoreboards 8327 Manual - Halaman 8
Jelajahi secara online atau unduh pdf Manual untuk Olahraga & Luar Ruangan All American Scoreboards 8327. All American Scoreboards 8327 15 halaman. Racing scoreboards
Halaman Cetak
Advanced ID Changing Scenarios (Radio Units Only)
In most cases, IDs can be set by following the methods described in Changing the Scoreboard ID. The follow-
ing text describes some methods to change an individual scoreboard ID in circumstances where multiple
scoreboards are hooked up to the same circuit breaker.
Changing an ID to an Individual Board while while Multiple Scoreboards are On
-Using multiple Consoles (easy method).
Once a scoreboard is connected to a console and a sport, the ID cannot be changed until radio connection is
reset. The radio is connected until 30 seconds after the console connected to it is turned off. If the scoreboard
displays only time of day or blanks (time of day is turned off by setting the time to "0000" in setup), then no
radio connection is established and a scoreboard is ready to be linked.
1. Turn on circuit breaker to scoreboards.
2. Power up one console and select all the boards except for the one that requires an ID change. Select a sport
and ensure that all the scoreboards selected are properly functioning.
3. Power up a second console and follow directions for changing IDs (steps 2-6)
If more than 1 scoreboard is selected, the ID numbers will be the same. Scoreboards that have the same ID number
can ONLY be run in dual mode!
-Using 1 Console (difficult method).
Once a scoreboard is connected to a console and a sport, the ID cannot be changed until radio connection is
reset. The radio is connected until 30 seconds after the console connected to it is turned off. If the scoreboard
displays only time of day or blanks (time of day is turned off by setting the time to "0000" in setup), then no
radio connection is established and a scoreboard is ready to be linked.
Because of this 30 second delay from the time the console is turned off, there is a short window of time to set
or change IDs to boards not currently selected.
1. Turn on circuit breaker to scoreboards.
2. Power up the console and select all the boards except for the one that requires an ID change. Select a sport
and ensure that all the scoreboards selected are properly functioning.
3. Turn off the console.
4. Turn on the console and quickly follow directions for changing IDs (steps 2-6). IDs must be set before the 30
seconds expire and the previously selected boards go to time of day or blank. The newly ID'd boards will go
through the startup cycle.
If more than 1 scoreboard is selected, the ID numbers will be the same when changed. Scoreboards that have the
same ID number can ONLY be run in dual mode! If all boards are set to the same ID, there is no way to change ID
numbers without disconnecting power to individual boards.
Advanced Scoreboard Type Settings (Radio and Hardwire Scoreboards)
If all boards that are selected are the same scoreboard type, it is possible to set the scoreboard type for the
entire group. Scoreboard type can be set without changing the ID by simply pressing enter rather than an ID
number (See Steps 1-7 in Changing Scoreboard ID). If the scoreboard is working properly, AAS recommends
leaving the scoreboard type unchanged by simply pressing enter instead of the 3 digit scoreboard type.
8