a-gear P1004T EPON Panduan Pemasangan Perangkat Keras - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Titik Akses Nirkabel a-gear P1004T EPON. a-gear P1004T EPON 13 halaman. Optical network unit

Halaman Cetak
A-GEAR World Wide Manufacturing
Acc es s Device
1.
This chapter mainly describes and introduces overall characteristics and parameters of
A-GEAR P1004T EPON access device so that readers can get an overall understanding about
A-GEAR P1004T EPON.
1.1.
D e s c r i pt io n of o u t l i n e i n s t a n dard co n f ig u ratio n
A-GEAR P1004T EPON interface consists of the following parts: 4 100-MB RJ45 ports, 1
GEPON optical port, 1 Power port, 1 switch, 1 Reset and 1 ground point. See following table
for detailed description.
Por t n a m e
LAN1~4
GEPON optical port
Power port
Switch switch
Comp on e n t
E n g l is h
No.
n a m e
1
LAN1~4
2
PON
3
RST
4
POWER
5
SWITCH
6
—
A-GEAR P1004T EPON Optical Network Unit (ONU)
Figure 1-1. Front Panel View of A-GEAR P1004T EPON.
Table 1-2. Description of Front Panel Components of A-GEAR P1004T EPON
C h in e s e n am e
RJ45 Ethernet Port
GEPON optical port
Reset key
Power supply port
Power switch
Ground point
Table 1-1. Characteristics of the Ports
De s cr ip tio n
RJ45 100MB Ethernet port, link cable
SFF, link optical fibre
Link power supply
Control device switch
De s cri pt io n
100MB Ethernet port, connecting
Ethernet cable
SFF INTERFACE, connecting optical fibre
Used for reset operation of the
equipment
Connecting power supply, used to
supply power for the equipment
Switch of the control device
Through the screw of this point, the
equipment outer casing is grounded
datasheet
a-gear.net
Раge 3 of 13