AEG 35610C Panduan Petunjuk Pengoperasian - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kompor AEG 35610C. AEG 35610C 28 halaman. Gas hob
Juga untuk AEG 35610C: Panduan Pengoperasian dan Instalasi (24 halaman), Petunjuk Pengoperasian dan Pemasangan (24 halaman)

A. EARTH CONTINUITY CHECK

Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and

adjust zero if necessary.

— Test leads from any appliance earth point to earth pin on plug. Resistance should be

less than 0.1 Ω (Ohm), check all earth wires for continuity and all contacts are clean

and tight.

B. INSULATION CHECK

Appliance electrically disconnected, all switches ON.

a) meter set on Ω (Ohms) x 1 scale.

Test leads from L to N in appliance terminal block. If meter reads «0» then there is a

short circuit.

b) meter set on Ω (Ohm) x 100 scale.

Repeat test with leads from L to E. If meter reads less than ∞ (infinity) there is a fault.

NOTE - Should it be found that the fuse has failed but no fault is indicated - a detailed continuity

check (i.e. by disconnecting and checking each component) is required to trace the faulty

component.

It is possible that a fault could occur as a result of local burning/arcing but no fault could be found

under test. However a detailed visual inspection should reveal evidence of burning around the

fault.