Fujitsu PRIMERGY BX620 S5 Manual Opsi - Halaman 16

Jelajahi secara online atau unduh pdf Manual Opsi untuk Server Fujitsu PRIMERGY BX620 S5. Fujitsu PRIMERGY BX620 S5 50 halaman. Server blade

Installation and operation

CAUTION!

Read the notes on installation and operation in the operating manual

of the BX600 S3 basic unit.

When installing the server blade in the basic unit, beware of the

energy hazard at the midplane contacts. A short-circuit on these

contacts may damage the system.

Data cables must be adequately shielded to avoid interference.

For the LAN wiring, the requirements according to standards EN

50173 and EN 50174-1/2 apply. The minimum requirement is the use

of a protected LAN line of category 5 for 10/100 Mbit/s Ethernet,

and/or of category 5e for Gigabit Ethernet. The requirements of the

specification ISO/IEC 11801 must also be taken into account.

Route the cables in such a way that they do not form a potential

hazard (tripping) and cannot be damaged. When connecting the

device, refer to the relevant notes in the operating manual.

Do not connect or disconnect any data transmission cables during a

thunderstorm (lightning hazard).

Make sure that no objects (such as bracelets or paper clips) or liquids

get inside the device (risk of electric shock or short circuit).

In emergencies (e.g. damaged casing, control elements or cables,

penetration of liquids or foreign bodies), switch off the device immedi-

ately, unplug it from the grounded power outlets, and contact your

customer service center.

Proper operation of the device (in accordance with IEC60950/EN

60950) is only ensured if the casing is completely assembled and the

rear covers for the installation openings are in place (electric shock,

cooling, fire protection, interference suppression).

Options Guide

Notes on safety

BX620 S5