Fujitsu ETERNUS DX8000 series Panduan Konfigurasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX8000 series. Fujitsu ETERNUS DX8000 series 17 halaman.
Halaman Cetak
Chapter 2
ETERNUS DX Connection Settings
2.1
Common Settings
This section explains the settings required for all server OSs, regardless of the connection configuration. For
details of how to use ETERNUSmgr to perform these settings, refer to the "ETERNUSmgr User Guide".
2.1.1
Setting the To-server Connection Type (Setting the CA Parameters)
For each connection configuration, perform the following iSCSI port parameter settings only. All other
parameters should be left on their default values.
Table 2.1
TCP/IP Setting
IP Address
Subnet Mask
Gateway
iSNS Server
iSCSI Settings
iSCSI Name
Alias Name
Security
CHAP
User Name
New Password
New Password (Re-enter)
General Settings
Affinity Mode
Host Affinity
Host Response
CA parameter settings (iSCSI port settings)
Parameter
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server
Arbitrary
Arbitrary
Arbitrary
Select "ON" to use the iSNS server, and specify the IP address for the iSNS
server.
Arbitrary
Caution:
When configuring multipaths, specify a different name for each iSCSI port.
If the same iSCSI name is specified for multiple ports, connection via
multipaths may not be available.
Arbitrary
OFF (Default value): When both unidirectional CHAP authentication and
bidirectional CHAP authentication are not used
ON: When either unidirectional CHAP authentication or bidirectional CHAP
authentication is used
When using bidirectional CHAP authentication, set a password.
When using unidirectional CHAP authentication, a CHAP user name and
password do not need to be set.
OFF (Default value): When not using Affinity Mode
ON: When using Affinity Mode
ON
Not available ( When "Host Affinity" is set to "ON")
8
Copyright 2014 FUJITSU LIMITED
P3AM-3972-08ENZ0