Brother CP-2000 Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Brother CP-2000. Brother CP-2000 33 halaman. Copyboard
Juga untuk Brother CP-2000: Panduan Pengguna (19 halaman), Brosur & Spesifikasi (4 halaman), Daftar Referensi Bagian (18 halaman)

Halaman Cetak

With the copyboard mounted on the wall, remove the two knobs on

the bottom of the unit, and then attach the long ends of the two

enclosed L-shaped brackets to the bottom of the unit with the two

knobs.

With the short ends of the L-shaped brackets against the wall, mark the

wall at the two points where the anchors will be installed, and then

remove the copyboard from the wall-mounting bar.

Install the two anchors as described in steps

ing the wall-mounting bar on page 9.

Remove the screws from the anchors, hang the copyboard back onto the

wall-mounting bar, and then attach the L-shaped brackets to the wall by

re-installing the screws, while making sure to use the enclosed washers.

Regularly check that the copyboard is securely mounted to the wall in

order to reduce the risk of the copyboard falling down.

When removing the copyboard from the wall, also remove the L-shaped

brackets.

Attach the tray by sliding its slots on each sides of back of the tray over

the two brackets on the front of the copyboard above the printer.

If the copyboard is mounted horizontally, the ends of the tray can be

pulled out to extend it.

Do not subject the tray to strong impacts or use it in any way other than

for holding markers and erasers.

2. Setup

through

of Attach-