AEG 925513017 Panduan Pengguna - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku AEG 925513017. AEG 925513017 40 halaman.
Halaman Cetak
Problem
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
ENGLISH
Solution
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
Refer to "Operation" .
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Add less food products at the
same time.
Defrost the appliance.
13