AEG SCT71906S0 Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku AEG SCT71906S0. AEG SCT71906S0 24 halaman.

Halaman Cetak

www.aeg.com

9.3 Ventilation requirements

The airflow behind the appliance must

be sufficient.

5 cm

CAUTION!

Refer to the assembly

instructions for the

installation.

9.4 Door reversibility

1. Loosen and remove the upper pin

and the spacer.

2. Remove the upper door.

3. Unscrew the pins (B) and spacers (C).

4. Remove the door.

5. Remove the lower spacer.

6. Loosen the lower pin with a key.

min.

200 cm

min.

200 cm

7. Tighten the lower pin on the

opposite side.

8. Install the lower spacer.

9. Install the door.

10. Refit the pins (B) and the spacers (C)

on the middle hinge on the opposite

side.

11. Tighten the spacer and the upper

pin.

Do a final check to make

sure that:

• All screws are tightened.

• The magnetic seal

adheres to the cabinet.

• The door opens and

closes correctly.

If the ambient temperature

is cold (i.e. in Winter), the

gasket may not fit perfectly

to the cabinet. In that case,

wait for the natural fitting of

the gasket.

In case you do not want to

carry out the above

mentioned operations,

contact the nearest

Authorised Service Centre.

The Authorised Service

specialist will carry out the

reversibility of the doors at

your cost.

9.5 Installing the appliance

CAUTION!

Make sure that the mains

cable can move freely.

1. If necessary cut the adhesive sealing

strip and then apply it to the

appliance as shown in figure.