ACA SPC-01 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol ACA SPC-01. ACA SPC-01 4 halaman.

8. DAC Control

The DAC output is fully automatic therefore there are no user adjustable parameters.

If this system is used in a vehicle to control cabin pressure, ensure that the static

Please note:

pipe is placed in a position where it is out of direct air flow when the vehicle is moving at speed

as this will result in pressure reading fluctuations due to varying pressures detected on the

static pipe.

9. Precautions

Handling:

This is a very sensitive instrument with delicate internal electronics so careful

handling is highly recommended.

Transport:

When transporting, please ensure that adequate packaging is used to reduce the

chances of damage to this instrument.

Mounting:

Always mount this instrument in a safe location unlikely to be knocked or hit and

ensure adequate cable protection to reduce the chances of it being cut or damaged during

normal operation.

Do not mount near water or where it is likely to suffer from condensation or moisture as that

can cause irreparable damage to the internal electronics.

10. Warranty

All our products come with a standard warranty period of 12 months from the date of purchase, against any

manufacturing faults or defects and can be replaced free of charge at our Springwood facility in Queensland if

proved to be a manufacturing fault.

We will not be responsible or liable for any damages caused to or for loss of machinery, equipment, production

costs, shipping, or handling in the event of a unit failure and will not be liable for any third-party claims.

Our warranty does not cover faulty controllers due to improper or faulty installations, bad or wrong electrical wiring

and excessive voltages leading to electronic or electrical damage or physical shock due to the device being dropped

or installed in an area with excessive vibration and does not cover the pressure sensor failure when the pressure or

application exceeds those parameters stated in these instructions.

For technical support please contact:

AUS Controls and Automation Pty Ltd

Tel: +61 7 3208 5448

Mob: +61 427 702 691

Website:

www.auscontrols.com.au

Email: