Kohler K582 Panduan Pemilik - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler K582. Kohler K582 17 halaman. Four-cycle, twin cylinder, air-cooled engine
- 1. Safety Information
- 2. California Proposition 65 Warning
- 3. Oil Recommendations
- 4. Fuel Recommendations
- 5. Engine Identification
- 6. Cold Weather Starting Hints
- 7. Maintenance Instructions
- 8. Maintenance Schedule
- 9. Carburetor Troubleshooting and Adjustments
- 10. Troubleshooting
- 11. Parts Ordering
- 12. Major Repair
- 13. Model Designation
- 14. Specifications
Operating Instructions
Also read the operating instructions of the equipment this engine powers.
Pre-Start Checklist
Check oil level. Add oil if low. Do not overfill.
Check fuel level. Add fuel if low.
Check cooling air intake areas and external
surfaces of engine. Make sure they are clean and
unobstructed.
Check that the air cleaner components
and all
shrouds, equipment
covers, and guards are in
place and securely fastened.
Check that any clutches or transmissions
are
disengaged
or placed in neutral. This is especially
important on equipment'with
hydrostatic
drive.
The shift lever must be exactly in neutral to
prevent resistance which could keep the engine
from starting.
A
WARNING:
Lethal Exhaust Gases!
Engine exhaust gases contain poisonous carbon
monoxide. Carbon monoxide is odorless, colorless,
and can cause death if inhaled. Avoid inhaling exhaust
fumes, and never run the engine in a closed building
or confined area.
Cold Weather Starting Hints
1 .
2.
3.
4 .
Be sure to use the proper oil for the temperature
expected. See Figure 2 on page 4.
Declutch all possible external
loads.
A warm battery has much more starting capacity
that a cold battery.
Use fresh winter grade fuel. NOTE: Winter grade
gasoline has a higher volatility
to improve
starting. Do not use gasoline
left over from
summer.
Starting
1. Move the throttle control lever to IDLE (slow)
position. For engines without automatic
choke,
move choke lever into full choke position and
gradually
return to OFF position after engine
starts and warms up.
2. Start the engine as follows:
For an Electric Start Engine - Activate the
starter switch. Release the switch as soon as the
engine starts.
NOTE:
Do not crank the engine continuously
for
more than 10 seconds at a time. If the
engine does not start, allow a 60 second
cool down period between starting
attempts. Failure to follow these
guidelines
can burn out the starter motor.
NOTE:
If the engine develops sufficient
speed to
disengage the starter but does not keep
running (a false start), the engine
rotation must be allowed to come to a
complete stop before attempting
to
restart the engine. If the start is engaged
while the flywheel
is rotating, the starter
pinion and flywheel
ring gear may clash,
resulting in damage to the starter.
If the starter does not turn the engine over, shut
off starter immediately.
Do not make further
attempts to start the engine until the condition
is
corrected.
Do not jump start using another battery
(refer to "Battery" below). See your Kohler Engine
Service Dealer for trouble analysis.
Stopping
Turn ignition switch OFF.
Figure 5.
Instrument
panel is standard on basic engine. Choke,
throttle, oil pressure gauge, ammeter, start button, and
stop switch are all positioned for easy operation.
Battery
A 12 volt battery is normally used. Refer to the
operating instructions
of the equipment
this engine
powers for specific battery requirements.
If the battery charge is not sufficient to crank the
engine, recharge the battery (see page 10).
6