Acano Solution Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Acano Solution. Acano Solution 17 halaman.

9. Attach the outer rail section to the sides of

the rack using the supplied M5 screws and

cage nuts (see figure 4). Use two screws

at the back and two screws at the front of

each rail (eight in total).

10. With another person, lift the server up to

the rack and slide the two rail sections

together on each side.

11. Secure the server in the rack with the rack

ears using two M5 screws for each rack

ear.

Note: Do not support the Acano Server

on the rack ears alone.

12. Unpack the box containing the two power supplies. They are identical.

13. Move to the back of the rack and slide the power supplies fully into the Power A and B slots

in the back of the server until they latch (see Figure 2).

Notes:

Do not connect power to the server at this time.

DC power option only: See

power at this time.

14. Connect a network cable to the Admin interface and to your administrator network.

This interface is used to set up time servers and to upgrade the software version. (Both are

outside the scope of this Installation Guide.) Connections to the Admin interface are via SSH

or SFTP.

15. Connect a network cable to the A interface and to your production or testing network.

This media interface is also used for access to the Web Admin Interface and therefore for

server configuration. An HTTPS connection is required – attempting to connect using HTTP

will fail. A certificate is required – as explained in later sections.

Note: Interfaces A to D will operate at the speed of the network switch that they are

connected to. If you are using a speed of 10G be sure to use the appropriate cable for the

Acano solution: Installation Guide 76-1002-04-D

Figure 4: Cage nut locations for the rack rails

Appendix A

for DC wiring instructions. Do not switch on the

Hardware Installation

Page 9