AVR Cinema Mirror HC 37.53 Petunjuk Dan Tips Untuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Dan Tips Untuk Instalasi untuk Aksesori Proyektor AVR Cinema Mirror HC 37.53. AVR Cinema Mirror HC 37.53 9 halaman.

Halaman Cetak

right

centred

left

INSTRUCTIONS AND TIPS FOR THE INSTALLATION

OF THE HC 37.53 MODEL CINEMA MIRROR

GENERAL RECOMMENDATIONS FOR ASSEMBLY AND INSTALLATION

INSTALLATION

UNPACKAGING AND PROCESS OF

ASEMBLY

Open the box of the Cinema Mirror and take

out the protection butt plates.

Take out the plastic covers.

Take out the rubber of protection of the

floodgate of the active mirror.

Place a fabric table cloth on a board, table,

bench, etc. to protect and take care of the

paintwork on the equipment gate. Separate

the bevel from the gate and leave it ready

to be installed later in the ceiling finish. Leave

Cinema Mirror on the table cloth.

Projectors do not always have the optic

in the same place; it can be to the left,

centred, or to the right.

For this reason, Cinema Mirror is equipped

with a tray called

(Fig. 5).

The variable position table has 5 positions:

1 centred, 2 moved to the left, 3 moved to

the right, 4 turned 180º and centred, and 5

turned180º and to the right.

figure 5

variable position table

Remove the 6 screws that secure the table

to the Cinema Mirror chassis.

Secure the variable position table, with its

screws, in the best place so that the projector

rests on its support feet.

Place the projector on the variable position

table horizontally centred relative to the

passive mirror. This will be its working place.

ADJUSTMENT OF THE PASSIVE

MIRROR

To centre in height the passive mirror, (Fig. 3

detail 6), in relation to the lens of the projector,

remove the screws that hold it to the chassis

and move them up and down so that the

centre of the mirror stays at the centre of the

lens of the projector. Tighten firmly, but not

to strong, the axis of the mirror to the holes

of the chassis, to make possible an ulterior

adjustment of the axis.

Place the graded plate supplied with the

equipment on the Cinema Mirror profile

(Fig. 6).

figure 6

The passive mirror should be placed to 37º

in relation to the base of the projector. Please

turn the passive mirror up so that the angles

between the mirror and the template

coincide in parallel. Fasten strongly the screws

of the axis of the passive mirror.