Avsl CSM660B Petunjuk Instalasi dan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Pengoperasian untuk Mikrofon Avsl CSM660B. Avsl CSM660B 3 halaman. Desktop paging microphone

Halaman Cetak
As you can see from the circuit diagram, the microphones' capsule is short-circuited by one half of the push-
to-talk switch. This means that the output wires (White & Red) are a short-circuit when the PTT switch is not
pressed, thus preventing any signal at all reaching the amplifier.
When the PTT switch is pressed, this short-circuit is removed, and the audio from the microphone capsule is
fed into the amplifiers' input. At the same time, the second half of the PTT switch places a short-circuit
across the Blue & Black wires and these may be used to trigger an external action e.g. the "Chime" in a local
device, such as the AVU2002 pre-amplifier/line driver.
IMPORTANT SAFETY NOTICE :-
For safety reasons, the shield (or screen) of the microphone cable must be earthed at the equipment end.
Most equipment with microphone inputs has its' chassis at earth potential, but some (typically low-voltage
supplied devices) may not. It is the installers' responsibility to ensure that the microphone is
adequately earthed!
MODEL
TYPE
Polar Pattern
Impedance
Sensitivity
Frequency Response
Connection Cable
Cable Length
Terminal Connector
Weight *
Dimensions
Talk Switch
Remote Switch
Finish
* Weight given in the above table does not include the connection cable or plug.
DOCUMENT NUMBER AVS/CSM660/OEM/01
TECHNICAL SPECIFICATIONS
CSM660B
Moving Coil Microphone
Unidirectional
600 Ohms, Balanced
-58db @1 KHz (0db = 1V Pa)
100Hz-10KHz
2 core shielded + 2 core cable
2.5m (8 ft 2 ins)
5 Pin DIN Plug
440 g (0.97 lb)
100 (W) X 215 (H) X 150 (D) mm (3.9 X 8.5 X 5.9 Ins)
Push-to-Talk (Short off circuit, with locking lever)
Leaf Spring Contact (Interlocked with Talk Switch)
HEAD : Zinc Plated Steel Wire, Baked Paint (Grey)
BODY : ABS Resin (Grey)
REV 2.0
th
25
November 2005
Page 3 of 3