ABB 9408 Series Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Industri ABB 9408 Series. ABB 9408 Series 20 halaman. Dissolved oxygen systems
Juga untuk ABB 9408 Series: Buku Petunjuk (20 halaman)

ABB 9408 Series Buku Petunjuk
3.2.2 Dip Systems – Fig. 3.4
Note.
• The standard dip system is supplied with the temperature probe and oxygen sensor body fitted. Before fitting the dip tube
to any bracket or fixing, remove the protective shroud, unscrew the dummy capsule from the end of the oxygen sensor
body and fit the oxygen sensor capsule to the sensor body (see Section 5.1 Replacing the Oxygen Sensor Capsule) and
replace the shroud. See section 3.1.2 for assembling dip kit systems.
• If the final mounting position of the dip system is inconvenient for wiring when fitted, wire the system prior to fixing – see
Section 4 ELECTRICAL INSTALLATION.
2
Fit a suitable pipe clamp
around the pipe and lightly
tighten the securing
device.
5
Make the necessary electrical
connections – see Section 4
ELECTRICAL INSTALLATION.
3.2.3 Submersible Systems – Fig. 3.5
Note. The submersible system is supplied with the
temperature probe and oxygen sensor body fitted.
Remove the protective shroud, unscrew the dummy
capsule from the end of the oxygen sensor body and fit
the oxygen sensor capsule to the sensor body (see
Section 5.1 Replacing the Oxygen Sensor Capsule)
and replace the shroud.
Note. Although a mounting
bracket is supplied, the user
may install a device more
suitable for the specific
application, e.g., a 'stilling well'.
With the wall mounting
1
bracket as a guide, mark
and drill the supporting
structure for mounting the
dip system.
Secure the pipe
clamp to the
support structure.
6
If applicable, arrange to have a water
wash mains supply available – see
Section 3.3 – and connect to the quick
fit connector on the end cap.
Fig. 3.4 Installing the Dip Systems
3 MECHANICAL INSTALLATION...
Note. A suitable mounting bracket is
required for Imperial kit system.
Note. Allow sufficient cable slack for
positioning/servicing procedure.
3
Position the dip system
in the pipe clamp for
correct monitoring and
tighten the clamp.
Note. The submersible
system is provided with a
screw fixing to enable it to be
suspended on a small chain
(not provided). This is to
prevent cable strain and
allows the system to be
lowered to the required depth.
Fig. 3.5 Submersible Systems
4
7