Dell Force10 MXL 10 GbE Panduan Memulai - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Server Dell Force10 MXL 10 GbE. Dell Force10 MXL 10 GbE 38 halaman. 10/40gbe blade switches
Juga untuk Dell Force10 MXL 10 GbE: Manual (27 halaman)

Halaman Cetak

Connect the USB connector on the cable directly to the switch console port.

The console port on the MXL 10/40GbE Switch is located below the fixed

40GbE ports (Figure 1-3).

Invoking the X-Loader and U-Boot CLIs

During the boot process, you can perform various configuration tasks by

accessing the X-Loader and U-Boot CLIs, such as running memory tests

(X-Loader) and activating the backup image or recovering a password

(U-Boot).

You are first prompted to enter the X-Loader CLI by pressing any key when

the following message is displayed: Hit any key to stop autoboot.

If you do not press a key, the boot process continues and you are prompted to

enter the U-Boot CLI by pressing any key.

After performing any of the X-Loader or U-Boot tasks, the switch

automatically reboots when you exit a CLI. To continue with the boot process

without entering either CLI, do not press a key.

Performing the Initial Configuration

Prerequisites: Before you perform the initial switch configuration, make sure

that:

•

The MXL 10/40GbE Switch was never configured before and is in the

same state as when you received it.

•

The MXL 10/40GbE Switch booted successfully when it powered on.

•

The console connection was established and the Dell Easy Setup Wizard

prompt appears on the screen of a VT100 terminal or terminal equivalent.

Perform the initial switch configuration through the console port. After the

initial configuration, you can manage the switch from the already connected

console port or through a remote connection.

Installing and Configuring the Switch