Dell Force10 S25-01-GE-24P Manual - Halaman 12
Jelajahi secara online atau unduh pdf Manual untuk Server Dell Force10 S25-01-GE-24P. Dell Force10 S25-01-GE-24P 48 halaman. Installing the s25p system
Juga untuk Dell Force10 S25-01-GE-24P: Panduan Konfigurasi (8 halaman)
Halaman Cetak
The following table describes the LED status indicators on the left side of the front panel.
Table 4 Status Panel LED Display
Label
LED Color
Green
Blinking Green
OK
Amber
Off
Green
AC1
Amber
Off
Green
XFP25*
Blinking Green
Off
Green
XFP26*
Blinking Green
Off
Stack ID
Green
Amber
Alarm
Red
Off
Green
AC2
Amber
Off
Green
XFP27*
Blinking Green
Off
Green
XFP28*
Blinking Green
Off
*Each of the four XFP LEDs on the front panel also indicate the status of a CX4 installed in the port.
12
Description
Left Side of the Status Panel
Unit is online.
Unit is booting up (blinking rate is 16 Hz).
Error during boot-up.
Unit is powered off.
Power supply 1 is present and OK.
Power supply 1 is present but failed (option).
Power supply 1 is not present.
A valid 10G link is established on the port.
Transmitting or receiving packets on the port.
No link is established on the port.
A valid 10G link is established on the port.
Transmitting or receiving packets on the port.
No link is established on the port.
The 7-segment LED indicates the stack ID of this unit.
Starting with FTOS 7.8.1.0:
•
"A" is displayed to the left of the stack ID if the unit is a standalone
or master (management) unit.
•
"B" is displayed for a standby unit.
•
"0" continues to be displayed next to the stack ID, as before, for the
other units.
Right Side of the Status Panel
Minor alarm: Fan or temperature is operating outside parameters.
Major alarm
No alarm
Power supply 2 is present and OK.
Power supply 2 is present but failed (option).
Power supply 2 is not present.
A valid 10G link is established on the port.
Transmitting or receiving packets on the port.
No link is established on the port.
A valid 10G link is established on the port.
Transmitting or receiving packets on the port.
No link is established on the port.
S25P System Overview