Dell PowerApp 110 Panduan Instalasi - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell PowerApp 110. Dell PowerApp 110 34 halaman. Rack installation guide
support.dell.com
Before You Begin
Before you begin installing your PowerApp appliance in the rack, carefully read "Safety
Instructions" , found earlier in this guide.
NOTICE: This rack kit is intended to be installed in a Dell rack by trained
service technicians. If you install the kit in any other rack, be sure that the
rack meets the specifications of American National Standards Institute
(ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92,
International Electrotechnical Commission (IEC) 297, and Deutsche Indus-
trie Norm (DIN) 41494. One rack kit is required for each Dell server,
storage system, or appliance that is installed in a rack.
Recommended Tools and Supplies
You need the following tools and supplies to install the appliance in a four-post rack
cabinet:
•
A #2 Phillips screwdriver
•
A flat-blade screwdriver
•
Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your PowerApp appliance, the slide
assemblies may be preinstalled in the rack.
For instructions on installing the PowerApp appliance itself, see "Installing the
Appliance in the Rack" found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.
Remove the rack's front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Rack Installation Guide
1-13