Dell PowerEdge PDU Metered LCD Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Server Dell PowerEdge PDU Metered LCD. Dell PowerEdge PDU Metered LCD 11 halaman. Site planning guide
Juga untuk Dell PowerEdge PDU Metered LCD: Manual (11 halaman), Manual (11 halaman), Manual (9 halaman), Panduan Perencanaan Lokasi (8 halaman)

Halaman Cetak
Dell PowerEdge PDU Metered LCD Manual
Cable Routing Procedures for the Dell PowerEdge R520 System
Section 3: Cabling a PowerEdge R520 system on sliding rails
without a CMA
NOTE: The CMA for the Dell PowerEdge R520 system is optional. Without the CMA installed, the system
must be powered down and all cables disconnected before it can be extended out of the rack.

3.1. Routing the cables

1. Connect all applicable cables to the rear of the system and verify that all connections are secure.
2. Using the hook-and-loop straps supplied with the rail kit, bundle the cables and secure them to
either the left or right outer CMA attachment bracket as described in the Rack Installation
Instructions. See Figure 10 for an example of data cables secured to the left outer CMA bracket and
power cables secured to the right outer CMA bracket (as viewed from the rear of the system).
Figure 10.

3.2. Removing the outer CMA brackets for shallow racks

If you are installing the system into a shallow rack (less than 1 meter deep) and you will not be
installing a CMA, the outer CMA brackets may be removed from the sliding rails if necessary in order to
allow the rails to fit properly into the rack. Remove the brackets by using a #2 Phillips screwdriver to
remove the screws that secure the brackets to the rails as shown in Figure 11. Use the hook-and-loop
straps supplied with the rail kit to secure the cables to the rack frame if desired.
Cable routing on sliding rails without a CMA
10