Dell E2210 Panduan Pengguna - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Dell E2210. Dell E2210 35 halaman. 19", 22" monitors e series
Juga untuk Dell E2210: Panduan Pengaturan Cepat (2 halaman), Spesifikasi (2 halaman)

Halaman Cetak
Dell E2210 Panduan Pengguna
Back to Contents Page
 

Troubleshooting

Dell™ E1910/E2210 Flat Panel Monitor
  Self-Test
  Common Problems
  Product Specific Problems
  Dell Soundbar Problems
 
WARNING:
Before you begin any of the procedures in this section, follow the
 Self-Test
Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly
connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue
connector) cables from the back of computer.
3. Turn on the monitor.
The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.
While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously
scroll through the screen.
 
4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged.
5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning
properly.

Built-in Diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or
with your computer and video card.
NOTE:
You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode.
Safety
Instructions.
  or