Dell Force10 S50V Series Panduan Memulai Cepat - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Dell Force10 S50V Series. Dell Force10 S50V Series 25 halaman. Switches

•

All protective covers are in place.

•

Blank panels are installed if optional modules are not installed.

NOTE: A US AC power cable is included in the shipping container for powering

up an AC power supply. All other power cables must be ordered separately.

CAUTION: Electrostatic discharge (ESD) damage can occur if components

are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the system and its components.

CAUTION: The power supply cord is used as the main disconnect device;

ensure that the socket-outlet is located/installed near the equipment and is

easily accessible.

AC Power

For the S50V and S50N, to use AC only, connect the supplied AC power cord

first to the switch (receptacle on the right as you face the PSU side of the

chassis) and then to the power source. Connect the plug to the AC receptacle,

making sure that the power cord is secure. As soon as the cable is connected

between the system and the power source, the chassis is powered-up; there is no

on/off switch.

DC Power

To connect the chassis to the DC power source, follow the steps below:

Step

Task

Make sure that the remote power source (the circuit breaker panel) is in

the OFF position.

Remove the safety cover from the DC terminal block.

Connect the -48 V and -48 V RTN (Return) cables to the switch

terminals and then to the remote power sources, ideally on separate

circuit breakers.

Replace the safety covers on the DC terminal blocks.

If you are connecting both terminal blocks, do not supply power until

both terminal blocks are connected. You can supply power to either one

or both. The S50N-DC does not set a precedence for either power

source.

Installing the Hardware