32 Degrees PT Xtreme Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan paintball 32 Degrees PT Xtreme. 32 Degrees PT Xtreme 9 halaman.

Halaman Cetak

Internally, inspect the hammer/push strut assembly

and clean with warm water if necessary. Always lube

the internal parts after cleaning as described above.

Check the o-rings on the bolt and striker for wear and

replace if necessary. Standard tank o-rings work well on

the bolt, but don't use the black rubber type.

To ensure that your PT Xtreme will be operational at

the

paintball field, there are a few parts and tools you'll

need. The most common o-ring in the PT Xtreme is the

"tank" o-ring. If you need to change any of these o-

rings, you'll probably need an o-ring pick to remove the

old ones. You really should keep several of these on

hand at all times.

Adjusting the Velocity:

To adjust the velocity of your PT Xtreme, screw the

thumb screw velocity adjuster (found in the bag of

parts) into the rear lower hammer plug. By adjusting

your thumb velocity screw clockwise you will increase

your markers velocity. By adjusting your thumb veloci-

ty adjuster counter clockwise you will decrease your

v e l o c i t y .

Disassembly / Reassembly

Field stripping your PT Xtreme: First degas your marker,

and remove the feed tube along with any paintballs.

Step two remove your barrel from the marker. After

your barrel is removed apply pressure to the velocity

thumb adjuster and remove connecting pin. Let the pres-

sure off slowly to remove thumb adjuster. Once that the

velocity adjuster and lower chamber plug is removed

you will find and spring strut, main spring and striker

buffer. After these parts are removed simply pull back

the upper bolt, this will remove the upper bolt as well as

the lower bolt. That concludes the removal of the field

s t r i p p i n g p a r t s .

Advanced Disassembly: After completing your field strip-

ping you will be left with your main body, valve, trigger

assembly, and Co2 cartridge lock. You will now want to

remove the cartridge lock first. This can be done by

removing the connecting screw. Then remove your trig-

ger assembly. Once trigger assembly is removed the

belly of the main body will be exposed. You will notice a

black set screw which is used to hold your valve body in

place. Remove that set screw and the bolt in front of the

set screw. You are now ready to remove the valve from

the body. Upon removal of the valve you will have

access to the puncture pin, notice that the front of the

valve where the puncture pin is located has a spot to

place a standard screw driver. If you remove the punc-

ture pin face you will have access to the valve pin and

valve spring as well as the cup seal. You have successful-

ly disassembled your PT Xtreme. To reassembly follow

this procedure in reverse.