Awarepoint R1 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Awarepoint R1. Awarepoint R1 8 halaman.

Figure 1.1-2: Awarepoint Sensor model R1

The Sensor model R1 displays its status three visual indicators in the form of Light

Emitting Diodes (LEDs). The topmost LED indicates network status. Red indicates that

the Sensor cannot communicate with any other devices. Yellow indicates that it can

communicate with the Bridge but not the Appliance. Green means that it can

communicate with the Bridge and Appliance. The middle LED indicates network activity.

In normal operation, it will occasionally blink. The bottom LED (blue) indicates power. If

the device is plugged into an outlet that has power then it is illuminated.

The Sensor model S2 displays its status with one LED visual indicator. If it is off then the

device is defective or not powered. Red indicates that the Sensor cannot communicate

with any other devices. Yellow indicates that it can communicate with the Bridge but

not the Appliance. Green means that it can communicate with the Bridge and Appliance.

Awarepoint Sensor Installation

Sensors need to be located throughout the coverage area, including along the

perimeter. When installing Sensors, begin by installing Sensors near the Bridge and work

progressively outward in concentric circles. In this manner, you will minimize the

number of Sensors that must be moved.

Prior to installing the Sensors, the Appliance and Bridge must be installed correctly.

2.1

The Sensors are installed in standard electrical power receptacles. Prior to installing the

Sensor you must locate a powered outlet. Verify that the receptacle has power by using

an electrical tester.

Awarepoint Sensor S2

Installation Manual

Figure 1.1-3: Awarepoint Sensor model S2