Awarepoint S2 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Awarepoint S2. Awarepoint S2 8 halaman.

2.2

Secure Awarepoint Sensors

Once you have optimized the mesh network, remove the Sensor; apply double‐sided

tape strip to the top of the output faceplate and reinstall the Sensor, pressing firmly to

adhere.

CAUTION: To remove a sensor that has been secured in place, use the insulated

blade screwdriver to first remove the electrical faceplate and sensor from the wall,

then separate the sensor from the faceplate. NEVER reach behind the sensor in an

effort to insert or remove it from the outlet as electrical shock may occur if you

contact the electrical prongs while they are still inserted in the outlet. For insertion or

removal, grasp the sensor by the sides only.

2.3

Once you plug the Sensor into an outlet, it will attempt to connect to the Awarepoint

network. This process will take approximately one minute. When the Sensor has

completed this process, the Network LED will be illuminated Green. If the Sensor is

unable to connect to the network (out of range of a network or network not properly

configured), the Sensor will continue to attempt to connect to the network and the

Network LED will be Red.

Once the Sensor has successfully connected to the network, mark the Sensor location

and its MAC address on a paper copy of the map.

2.4

Open the System Manager and click on the Positioning: Configuration tab. The Sensor

you just installed should show up in the Unassigned section of the device tree. If it is

functioning correctly, the icon for the Sensor should be green.

In the device tree, expand the Campus and Building so that you can see the floor. Click

on the floor to display the map for the floor. Drag the Sensor icon onto the map and

place it where it is located.

Figure 2‐1: Positioning: Configuration Tab ‐ Placing Awarepoint Sensor

Awarepoint Sensor S2

Installation Manual