Miele DA 209 Panduan Petunjuk Pengoperasian - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kap Ventilasi Miele DA 209. Miele DA 209 36 halaman. Cooker

Installation

Retaining plate A

Drill a hole

worktop at a distance of

s + 425 mm.

Drill another hole

325 mm underneath the first hole

Press S8 plugs into the drilled holes.

Screw on the retaining plate using

5 x 40 mm screws and adjust.

Drill 4 more holes

the now mounted retaining plate and

press S8 plugs into the holes.

Screw in 4 screws 5 x 40 mm into

the plugs.

Drill 2 holes

later to secure the vapour guide and

press S8 plugs into the drilled holes.

8 mm Ø above the

8 mm Ø

8 mm Ø through

8 mm Ø to be used

Retaining plate B

Address the top retaining plate B

flush to the room ceiling and mark

the positions on the wall of the 4

bore holes

With a 6 mm Ø bit drill the 4 holes in

the wall and then press the S6 plugs

in the holes.

Screw in the top retaining plate with

4 screws 4 x 30 mm and 4.3 under-

lying washers.

If the measurement y from the top edge

of the hood to the ceiling is greater

than measurement z, it will be necess-

ary to fit retaining plate C for the tele-

scopic extension piece (see chart).

Hold the plate C in place so that the

distance between the ceiling and

bottom edge of the plate is z and

mark the positions for the 2 holes

to be drilled.