Miele DA 2450 Petunjuk Pengoperasian dan Pemasangan - Halaman 18
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi Miele DA 2450. Miele DA 2450 36 halaman.
Juga untuk Miele DA 2450: Petunjuk Pengoperasian dan Pemasangan (32 halaman), Petunjuk Pengoperasian dan Pemasangan (32 halaman)

Cleaning and care
Before proceeding with any
maintenance or cleaning task, the
cooker hood must be disconnected
from the power supply, see "Warning
and safety instructions".
Housing
General information
The surfaces and controls are
susceptible to scratches and
abrasion.
Please observe the following
cleaning instructions.
All external surfaces and controls can
be cleaned using hot water with a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.
Make sure that water does not get
into the cooker hood.
Only clean the area of the controls
with a damp cloth.
Then wipe the surfaces dry using a
soft cloth.
Do not use:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents.
18
Grease filter
The re-usable metal grease filter in the
appliance removes solid particles from
the kitchen vapours (grease, dust, etc)
preventing soiling of the cooker hood.
An oversaturated filter is a fire
hazard.
Cleaning interval
Grease which is left to accumulate over
time will harden and become difficult to
remove. The grease filter should
therefore be cleaned at least every 3 - 4
weeks.
Removing a grease filter
When handling a grease filter, be
careful not to drop it.
This can result in damage to the filter
and the hob below.
Make sure you hold the filter securely
at all times when handling it.
To take out a grease filter, release the
locking clip on the filter, lower the
filter approx. 45°, unhook it at the
back and remove it.