Miller XT30 Panduan Pemilik - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XT30. Miller XT30 44 halaman. Air plasma cutting and gouging
Juga untuk Miller XT30: Panduan Pemilik (40 halaman)
Halaman Cetak
4-7.
Duty Cycle And Overheating
35% Duty Cycle at 27 A, 92 VDC (120 V Input)
3-1/2 Minutes Welding
60% Duty Cycle at 20 A, 88 VDC (120 V Input)
40% Duty Cycle at 30 A, 92 VDC (240 V Input)
Overheating
4-8.
Environmental Specifications
A. IP Rating
This equipment is designed for outdoor use. It may be stored, but is not intended to be used for welding outside during precipitation unless
B. Temperature Specifications
Operating Temperature Range*
5 to 104°F (-15 to 40°C)
*Output is derated at temperatures above 104°F (40°C).
�
Complete Parts List is available at www.MillerWelds.com
6-1/2 Minutes Resting
0
15
Minutes
A
OR
Reduce Duty Cycle
IP Rating
IP23S
sheltered.
Duty Cycle is percentage of 10 minutes that
unit
can
cut
overheating.
If unit overheats, thermostat(s) opens, output
stops, Temperature trouble light goes On,
and cooling fan runs. Wait fifteen minutes for
unit to cool or temperature light to go off. Re-
duce amperage or duty cycle before cutting
or gouging.
NOTICE – Exceeding duty cycle can dam-
age unit and void warranty.
Storage/Transportation Temperature Range
-4 to 131°F (-20 to 55°C)
at
rated
load
without
OM-253555 Page 15