Miller I-24 CE Panduan Pemilik - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Aksesori Pengelasan Miller I-24 CE. Miller I-24 CE 36 halaman.
Halaman Cetak
4-1. Important Information Regarding CE Products (Sold Within The EU)
A. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
B. Information On Electromagnetic Compatibility (EMC)
!
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low−
voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations, due to con-
ducted as well as radiated disturbances.
4-2. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the rear panel. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.
4-3. Specifications
Welding
Type of Input
Power
Power
Source Type
Constant Voltage
24 Volts AC
(CV) DC With
Single Phase
14-Pin And
7 Amperes
Contactor
50/60 Hz
Control
4-4. Wire Type, Size and Feed Speed Table
Motor Speed
Wire Type
Standard
*Rated Speed Range Per IEC 60974-5
OM-186 895 Page 12
SECTION 4 − INSTALLATION
Wire
Wire Feed
Diameter
Speed
Range
0.6 To 2 mm
(.023 To 5/64 in.)
Max Spool
1.9 To 19 mpm
Capacity:
(75 to 750 ipm)
12 in. (305 mm)
Max Spool
Weight:
27 kg (60 lb)
Wire Size
.023 To 5/64 in.
All
(.6 to 2 mm)
Welding
IP
Circuit
Rating
Dimensions
Rating
Length: 597 mm
100 Volts,
(23-1/2 in.)
500 Amperes,
Width: 273 mm
100%
IP 21S
(10-3/4 in.)
Duty Cycle
Height: 279 mm
Rated Speed Range*
80 to 740 ipm
(2.0 to 18.8 mpm)
ce-emf 1 2010-10
ce-emc 3 2011-09
Overall
Weight
15.9 kg (35 lb)
(11 in.)