Miller XT60 Manual - Halaman 16

Jelajahi secara online atau unduh pdf Manual untuk Senter Miller XT60. Miller XT60 40 halaman.

Halaman Cetak

1. Section 7 − Parts List

3-5. XT40 Torch Specifications

Torch −

The XT40 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 625

X-TREME. Do not use this torch in combination with any other machines.

Gas Type

Gas Quality

Gas Inlet Flow and Pressure

Gas Filtering

Cooling Method

Duty Cycle of Torch

Rating of Electrical Controls (Trigger)

Rating of Electrical Controls (Cup)

Approved Systems

Trigger Protection

Safety Devices

Rated Capacity (edge start)

Sever Cut Capacity (edge start)

Pierce Capacity

*Travel speeds are approximately 80% of maximum.

Weight

Requirements for the torch connection

Use only compressed air which is free from dirt, oil, and water.

Ensure that the connections are properly assigned and tightened.

For torch replacement, see Miller torch manual Part No. OM-254449

Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.

3-6. XT40 Torch Dimensions

OM-254 449 Page 12

Spectrum 625 X-TREME w/XT40 torch

Safety interlock devices shut down power source

1-3/16 in.

(30 mm)

Air or Nitrogen

Clean, moisture−free,

oil−free

6.0 SCFM (170 L/min)

Particulates to 5 microns

Air

100% at 40 Amps

30 VDC at .1 Amps

30 VDC at 1 Amp

Safety trigger guard

5/8 in. at 13 ipm (330 mm/min)*

7/8 in. at 4 ipm (102 mm/min)*

5/16 in.

2.5 lb (1.1 kg) 12 ft (3.7 m)

3.4 lb (1.5 kg) 20 ft (6.1 m)

8-3/4 in.

(222 mm)

1-1/2 in.

(38 mm)

−−

90 PSI (621 kPa)

120 PSI (827

Min

kPa) Max

−−

− −

−−

− −

Ref. 253 554-A