AQUATECH LUX Flash Housing Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Kamera AQUATECH LUX Flash Housing. AQUATECH LUX Flash Housing 6 halaman.
Halaman CetakInitial setup
•
Additional Tools Needed: Flathead screwdriver,
Crescent wrench
•
Open LUX Flash Housing
•
Install four double AA batteries into right side of the
Godox Flash
•
To install Godox flash into LUX Housing make sure
Godox Hotshoe is unlocked by spinning locking
wheel all the way to the right
•
Then simply slide Godox flash into LUX flash
Hotshoe
•
Then spin the locking wheel to the left to ensure
Godox is properly installed and secure
•
Turn Godox Flash on, and lineup Lux Backplate
controls with Godox flash controls
•
Then clamp down Backplate
•
Remove the Flash Bulkhead plug from your Sport
Housing with a Flathead screwdriver turning counter
clockwise, install the supplied Flash Bulkhead onto
your Sport Housing making sure the two o-rings
are properly in place. Note: the additional Flash
Bulkhead will be found bagged with your grease,
hex key, Flash Sync Cable and camera hot shoe.
•
Once Flash Bulkhead is in attach female end of
Camera Hotshoe into male end of recently installed
Flash Bulkhead
•
Once the Flash Bulkhead is installed onto your
Sport Housing, attach the female end of the Camera
Hotshoe into male end of the Flash Bulkhead, slide
Camera Hotshoe into camera body
•
Unscrew cap from Lux Flash Bulkhead and Housing
Flash Bulkhead.
•
Remove caps from both ends of sync cord
•
Install one end of Sync cord into Lux Flash Bulkhead
Ensure it is correctly lined up by aligning electrical
pins
•
Move Sync cord cap forward and screw in clockwise
until secure
•
Attach other end of Sync cord into housing
Bulkhead following the previous steps.
•
Install supplied Flash Bulkhead by pulling through
the hole where the previous Flash Bulkhead was
•
Take Crescent wrench and grip flat side of Flash
Bulkhead and begin to spin clockwise. Make sure
O-Ring is not pinched
•
To install LUX Flash Housing you will need to
have the Pro Mount installed. Please refer to the
corresponding manual for Pro Mount installation
•
Push Quick Cam Mount through the slot on the Pro
Mount and securely screw into place
•
**After installing the provided additional Flash
Bulkhead onto your Sport Housing, please make
certain it is installed correctly by doing a "dunk"
test (without your camera installed). If there is any
moisture or water present after the "dunk" test is
performed, please contact AquaTech via
aquatech.net
so we can assist you with the reinstall
contact@
3