Aquatic AQ-BC-5UBT Panduan Pengguna dan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Instalasi untuk Pemutar Media Aquatic AQ-BC-5UBT. Aquatic AQ-BC-5UBT 14 halaman. Bluecube+ hide-away media player

Halaman Cetak

1. Remote Control Synchronizing

Getting Started

1.5 Power On

The AQ-BC-5UBT requires +12V DC to both the red and yellow wires. When both of these wires

have power the AQ-BC-5UBT is powered on and is indicated by a red LED on the harness grom-

met of the stereo.

In a spa application this requires the red and yellow wires to be jumped together and then con-

nected to the +12VDC output of the power source. In this set up the AQ-BC-5UBT will always be

on, with a very low current draw when idle.

In a boat, ATV or other application requiring power from a battery, the yellow wire (constant

power) should be connected to the battery, and the red wire connected to the ignition or a switch.

For detailed instructions you can check out our online video:

1.6 Remote Control Battery Install

Remove the RF wireless remote control from the BlueCube+ Media Player box. Unscrew the

waterproof cap on the back of the remote control. Place the CR2450 battery in the RF remote

control and replace the water/dust proof cap.

When the battery is installed, the remote control LCD should be solid and bright without any

flickering.

1.7 Remote Control Synchronizing

The remote should already be paired from the factory, but if you need to re synchronize the

remote follow the steps below.

1. Press the

2. The LCD will become illuminated and read 'NO LINK'.

3. Press and hold the

4. Once the remote has been paired, the LCD will display one of the audio modes (FM, USB,

BT AUDIO).

For any additional remote controls, you will also need to activate/synchronize those remote con-

trols by following the steps above.

If the pairing process is not effective, check the battery voltage of the remote. If above 3V DC refer to section 1.5 above

top make sure the battery is installed correctly. If battery voltage is below 3V DC replace the battery.

If the LCD displays "NO LINK" in any mode, this means the remote is out of reception range or not paired correctly.

Move the remote closer to the unit and try again.

If you lose your remote control and buy a new remote control, please follow the above to pair remote control.

www.aquaticav.com

'How to wire your Aquatic AV stereo system'

http://www.aquaticav.com/support/videos

POWER button on the remote control to turn on the remote.

MODE button for 5 – 10 seconds.

BlueCube+ Media Player AQ-BC-5UBT