Aquatic BLUECUBE6 BC6 MINI Panduan Pengguna & Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna & Instalasi untuk Pemutar Media Aquatic BLUECUBE6 BC6 MINI. Aquatic BLUECUBE6 BC6 MINI 15 halaman. Hide-away media player

Halaman Cetak
Getting Started

1.7 Electronic Crossover Mode

The BC6 MINI is capable of powering up to eight 4 Ohm speakers, however should you wish to
power a dual-voicecoil subwoofer, in addition to standard speakers, this can be achieved by using
the two rear speaker channels in Electronic Crossover Mode.
In Electronic Crossover Mode you will only be able to power up to four 4 Ohm speakers (two from
the front left channel and two from the front right channel) plus a dual voicecoil subwoofer. See
section 1.7.1.
Cut the Electronic Crossover wire (red/white stripe) to place the BC6 MINI in Electronic Crossover
Mode. You will now be able to use the left and right rear channels in Mono mode to power a dual-
voicecoil passive subwoofer, such as the Aquatic AV AQ-SWP8-2.
These modifications should only be carried out by an experienced audio installer.
In Electronic Crossover Mode the rear RCA outputs will also be affected by the crossover and will output only low-
frequencies below the crossover frequency.
1.7.1 Four Speakers & One Dual Voicecoil Subwoofer Set Up
Dual
Voice Coil
4 Ohm
4 Ohm
4 Ohm
www.aquaticav.com
Left Rear Speaker
LR- (2) (Green/Black stripe)
LR+ (3) (Green)
Right Rear Speaker
RR- (11) (Purple/Black stripe)
RR+ (12) (Purple)
Left Front Speakers
LF- (5) (White/Black stripe)
LF+ (6) (White)
Right Front Speakers
RF- (8) (Gray/Black stripe)
RF+ (9) (Gray)
BlueCube Media Player BC6 MINI
ACC (1) (Red)
Please put a fuse into
the fuse box
FUSE
BOX
+12V DC (4) (Yellow)
Power Antenna (7) (Blue)
DC Ground (10) (Black)
No lower then a 2 Ohm
load in stereo mode, or
4 Ohm load in Electronic
Crossover mode, should be
used. Damage may occur
to the BC6 MINI if incorrect
Ohm load is used.
Make sure the polarity of
speakers are connected
correctly.
6