Aquatic BLUECUBE6 BC6 MINI Panduan Pengguna & Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna & Instalasi untuk Pemutar Media Aquatic BLUECUBE6 BC6 MINI. Aquatic BLUECUBE6 BC6 MINI 15 halaman. Hide-away media player

Halaman Cetak

Getting Started

1.8 Power On

The BC6 MINI requires +12V DC to both the red and yellow wires. When both of these wires have

power the BC6 MINI is always powered on, indicated by a red LED on the heatsink of the BC6

MINI. Ground is connected to the black wire.

In a spa application this requires the red and yellow wires to be jumped together and then

connected to the +12VDC output of the power source. In this set up the BC6 MINI will always be

on, with a very low current draw when idle.

In a boat, ATV or other application requiring power from a battery, the yellow wire (constant

power) should be connected to the battery, and the red wire should be connected to the ignition

or a switch.

For detailed instructions you can check out our online video:

1.9 Handheld Remote Control Charging

The optional remote RF6 REMOTE KIT (sold separately) has a built-in Polymer Lithium re-

chargeable battery and comes with a charging cable. Connect one end of the charging cable

to the charging connection on remote control and connect the USB end of the charging cable

to any USB charger (5V DC) for charging.

Make sure the remote has been charged before used.

1.10 Handheld Remote Control Synchronizing

The optional remote RF6 REMOTE KIT (sold separately) should include an RF receiver and

should already be paired from the factory. Plug the RF receiver into the remote control 8-pin

DIN connections on the BC6 MINI. If you need to synchronize the remote, follow the steps

below.

1. Make sure BC6 MINI is powered ON (red LED)

2. Put the remote within 0.5 meter of the BC6 MINI.

3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress". Re-

lease the button.

4. Within 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show "Retry

again". If this happens, wait 5 seconds and repeat steps above.

For any additional remote controls, you will also need to synchronize those remote controls to

the BC6 MINI.

If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote

control if the battery is low.

Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD

shows nothing, the battery has been drained and will need charging.

If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the

new remote control.

www.aquaticav.com

'How to wire your Aquatic AV stereo system'

http://www.aquaticav.com/support/videos

BlueCube Media Player BC6 MINI