Aquatic AD504 Panduan Pemilik dan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik dan Instalasi untuk Penguat Aquatic AD504. Aquatic AD504 18 halaman. 4/3/2 channel amplifier

Important Information

AD500.4 - 4/3/2 CHANNEL AMPLIFIER

Congratulations on your purchase of an Aquatic AV AD500.4 4/3/2 Channel

Amplifier. It has been designed, engineered and manufactured to bring you the

highest level of performance and quality. Thank you for making Aquatic AV

your choice for marine audio equipment!

Working Safely With Your Battery

Disconnect the negative battery terminal before doing any electrical work. Al-

ways disconnect the negative (-) battery post first, followed by the positive (+).

When it's time go back together, connect the positive (+) post first, followed by

the negative (-). This can minimize the chance of sparks and voltage spikes.

Grounding

Always use the shortest length of ground wire possible between chassis

ground and the amplifier. Never use a ground wire longer than the one we

provide.

The ground wire and power wire are equally important; if either one of them is

compromised, the amplifier's performance will degrade or cease to function.

Fuses

Always install a master fuse within 12" of the battery for any additional equip-

ment added to your installation's electrical system. The mini-fuse installed

on the main amplifier only protects the internal circuitry, not the wiring. In the

event of a short, failure to install a fuse near the battery can cause damage to

your electrical system or the possibilty of fire.

Speaker Polarity

The way speaker wires are marked for polarity (+/-) varies from brand to brand.

Some manufacturers use the stripe as positive (+), while others use the stripe

as negative (-). Be sure to check the documentation of each component you're

dealing with before making connections.

Cutting Cables

Always route wires and cables safely, avoid sharp edges and burrs along the

way. Use wire loom when possible. Check for proper length to both termination

points, knowing where each component mounts, before you cut anything.

Mounting

Mount the amplifier away from water/mud at all times and in a good ventilated

area with good air flow. Do not mount in engine compartment. Mount amplifier

securely. Be careful not to drill into fuel line, electrical or mechanical areas

when mounting. Do not run wires under the vehicle or vessel, this could be very

dangerous with severe damage.