Aquatic AQ-AD300.2 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Aquatic AQ-AD300.2. Aquatic AQ-AD300.2 18 halaman. 2 channel waterproof amplifier

WIRING THE SPEAKERS

5. Install 4 ohm or 2 ohm speakers of your choice, if they are not already installed.

6. Route and connect the speaker wires from each speaker of your system to the cor-

responding speaker output terminal block on the amplifier (right/left).

Keep the polarities (+/–) of each wire pair correct between the amplifier(s) and

speakers.

TESTING & TUNING THE SYSTEM

7. Re-connect the positive (+) side of the battery, followed by the negative (-) side.

Do not install the in-line fuse until after this step. This is a good time to re-check

your connections before installing the fuse. Make sure that all control cables are

completely seated and latched in their respective connectors, and that power and

ground are properly connected to the main amplifier.

8. Install the 25 amp ATC fuse into the in-line fuse holder on the power wire.

9. Perform a basic system test, verifying that the amplifier(s) power up (led on each

component should light) and that the speakers function properly. If not, proceed directly

to Troubleshooting in the User Guide section.

10. Configure, test, and tune your system by following the Test and Tune instructions

given in the User Guide section of this manual. When you've completed these instruc-

tions the installation is complete.

INSTALLATION