Aquatic AQ-AD600.4 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Aquatic AQ-AD600.4. Aquatic AQ-AD600.4 12 halaman. 4/3/2 channel waterproof amplifier

Halaman Cetak

Important Information

4/3/2 Channel Waterproof Amplifier AQ-AD600.4

Congratulations on your purchase of an Aquatic AV AQ-AD600.4 Amplifier. It has been designed,

engineered and manufactured to bring you the highest level of performance and quality, and will

afford you years of listening pleasure. Thank you for making Aquatic AV your choice for marine

audio entertainment!

1.1 Using Your Amplifier

Working safely with your battery

Disconnect the negative battery terminal before doing any electrical work. Always disconnect the

negative (–) battery post first, followed by the positive (+), and when it's time to go back together,

connect the positive (+) post first, followed by the negative (–). This can minimize the chance

of sparks and voltage spikes, and is a good general practice when dealing with any DC electrical

system.

Grounding

Bad grounds under are the number one cause of problem installs.

Always use the shortest length of ground wire possible between chassis ground and the amplifier.

Never use a ground wire longer than the one we provide.

The ground wire and power wire are equally important; if either one of them is compromised, the

amplifier's performance will degrade or cease to function.

Fuses

Always install a master fuse within 12" of the battery for any additional equipment added to your

installations electrical system. The mini-fuse installed on the main amplifier only protects the

internal circuitry, not the wiring. In the event of a short, failure to install a fuse near the battery

can cause damage to your electrical system or the possibility of fire.

Speaker Polarity

The way speaker wires are marked for polarity (+/–) varies from brand to brand. Some manufactur-

ers use the stripe as positive (+), while others use the stripe as negative (–). Be sure to check the

documentation of each component you're dealing with before making connections.

Cutting Cables

Always route wires and cables safely, avoiding sharp edges and burrs along the way. Use wire loom

when possible. Check for proper length to both termination points, knowing where each compo-

nent mounts, before you cut anything.