Aquatic Access IGAT-180/135 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Pengangkatan Aquatic Access IGAT-180/135. Aquatic Access IGAT-180/135 18 halaman.

Halaman Cetak

Aquatic Access Model IGAT-180/135

The customer and installer are responsible for assuring the strength of the mounting for the pool

lift and for determining if grounding the unit is necessary. These installation instruction must be

followed to meet advertised lifting capacities.

SOCKET PLACEMENT

The customer or installer and Aquatic Access mutually agree upon the socket location. Usually,

the customer provides Aquatic Access with

a drawing showing the measurements and

configuration of the deck, coping, gutter,

and pool wall. This allows our engineers to

determine the best location for the socket. The

pool lift should normally be located where

there is at least 36" of straight vertical pool

wall. The depth would need to be greater if

there is a curve instead of a right angle at the

pool bottom. The depth range of 42"– 48"

(deck to pool floor) is ideal.

It is recommended that the lift be installed 48" (minimum 36") from inside pool corners and

(IN-GROUND AUTOMATIC-TURN OF 135°)

INSTALLATION

ladders that could interfere with the turn of the seat. The

socket should not be placed directly on an expansion

joint, but at least 4" away from it. If unsure about the

measurements, configurations or structural integrity,

have a local contractor verify them.

If you have received the socket in advance of the lift

without instructions as to how far away from the pool

edge to install the socket, or if any questions remain,

consult with the engineers at Aquatic Access before

installing the socket.