Panasonic SA-AK580 Panduan Petunjuk Pengoperasian - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Panasonic SA-AK580. Panasonic SA-AK580 20 halaman. Cd stereo system
Juga untuk Panasonic SA-AK580: Panduan Petunjuk Pengoperasian (20 halaman)

Panasonic SA-AK580 Panduan Petunjuk Pengoperasian
■ Unit displays
"NO PLAY"
"F61"
"ERROR"
"ERROR" (during recording)
"VBR–"
"– –:– –" (during standby
mode)
"USB OVER CURRENT
ERROR"
"HI-SPEED CAN'T REC"
"DEVICE FULL"
Memory reset (Initialisation)
When the following situations occur, refer to the instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset memory
1 Disconnect the AC mains lead. (Wait at least 3 minutes before proceeding to step 2.)
2 While pressing and holding down [y/I] on the main unit, reconnect the AC mains lead.
"– – – – – – – – –" appears on the display panel.
3 Release [y/I].
All the settings are returned to the factory preset.
You will need to reset the memory items.

Maintenance

If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.

When moving the unit

1
Remove all discs.
2
Press [y/I] to turn the unit off.
3
Disconnect the AC mains lead.
RQTX0271-B_GB.indd 19
RQTX0271-B_GB.indd 19
• Check the content.
• Only MP3 format fi les can be played.
• Disconnect the USB device. Turn the unit off and then turn back on.
Alternatively, format the USB device and record the desired tracks again and playback the
device.
• Check and correct the speaker cords connection.
If this does not fi x the problem, consult the dealer.
• Disconnect the USB device. Turn the unit off and then turn back on.
• Incorrect operation performed. Read the instructions and try again.
• You are not able to select other playback source (example: radio, USB and etc.) or press
[4 / 1] or [¡ / ¢] during recording.
Stop the recording function.
• You are not able to open the disc tray when recording from AM source.
• Select a suitable recording mode (128 KBPS or 192 KBPS) and resume recording.
• The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
• You plugged the AC mains lead in for the fi rst time or there was a power failure recently.
• Set the time.
• The USB device is drawing too much power. Disconnect the USB device. Turn the unit off
and then back on.
• You cannot use high-speed recording while using analogue mode. Change to digital mode
or use normal recording.
• You cannot perform recording because the total USB remaining REC (recording) time of
the USB device is less than the total time of the music source.
Change to a USB device which has the appropriate recording time and perform the
recording again.
Page
14
5
12
14
15
13
12
19
5/6/09 11:00:30 AM
5/6/09 11:00:30 AM