Alphamount APCH01B Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Sepeda Motor Alphamount APCH01B. Alphamount APCH01B 2 halaman. Kid bicycle helmets

Halaman Cetak

Important Safety Information

• Please use the helmet under the parent's supervision

•Please carefully read all instructions before attempting installation. If

you do not understand the instructions or have any concerns or ques-

tions, please contact our customer service at [email protected].

• CAUTION: Avoid potential personal injuries and property damage!

• This helmet is designed to absorb the energy of a blow by partial

destruction or damage itself. Even though such damage may not be

visible, the helmet should be destroyed or replaced, if it is involved in an

injury- related fall.

• Unfortunately, some accidents result in head injury that cannot be

prevented by ANY helmet. Depending on the type of impact, even very

low speeds can result in a serious head injury or fatality. Always ride

with extreme caution and be sure to read this manual thoroughly.

• The helmet is designed and intended exclusively for use while cycling,

and other non-motorized sports. It is not intended for and will not

provide adequate, safe protection if used during motor sport or moped

use. No helmet can protect the wearer against all unforeseeable

impacts. However, for maximum protection, the helmet must be ﬁtted

well and all retention straps must be securely fastened.

• Please keep helmet out of extreme heat. Helmets will be damaged if

exposed to temperatures exceeding 150° F. Dark vehicles and storage

bags can exceed this on very hot days. Heat damaged helmets will have

Step 1

random disﬁgured areas where the texture appears bubbly and uneven.

If damaged, helmets should be destroyed and replaced immediately.

• Clean the helmet with mild soap and water only.The use of any

solvents, paints or decals can cause damage to the helmet and make it

ineﬀective in the result of an accident.

• The helmet is applicable to the people with head circumference in a

range of 18.11-20.47in.(46-52cm)

Installation steps

1. To proper wear the helmet, put the helmet on your head ﬁrst.

2. (Refer to Fig. A)Then adjust the tension around the head by rotating

the dial ﬁt.

Fig. A

Turn count-

er-clockwise

to enlarge the

head circumfer-

ence

Adjustable Range of the Dial

Fit: 18.11-20.47in.(46-52cm)

3. (Refer to Fig. B)If the strap is too loose or tight, you can take oﬀ the

helmet to adjust the straps to proper length.

Situation A: If the front chin strap is too loosen, hold the buckle [a] with

one hand. Then pull the excess chin strap in through.

Situation B: If the rear strap is too loose, hold the buckle with one hand.

Then pull the excess rear strap in through.

Fig. B

Front Chin Strap

Buckle [a]

Step 3

4. (Refer to Fig. C)Hold the helmet with one hand, and hold the strap

where they pass under your chin with the other hand. Then pull the strap

from side to side to balance the length of all four straps.

Turn clockwise to

narrow the head

circumference

Rear Strap