Axor 250 /250 1jet 35306007 Petunjuk Penggunaan/Petunjuk Perakitan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Penggunaan/Petunjuk Perakitan untuk Perlengkapan Kamar Mandi Axor 250 /250 1jet 35306007. Axor 250 /250 1jet 35306007 16 halaman.

Halaman Cetak

S A F E T Y N O T E S

Gloves should be worn during installation to prevent

crushing and cutting injuries.

The shower may only be used for bathing, hygiene and

body cleaning purposes.

I N S T A L L A T I O N I N S T R U C T I O N S

⁄ Prior to installation, inspect the product for transport

damages. After it has been installed, no transport or

surface damage will be honoured.

⁄ The pipes and the fixture must be installed, flushed and

tested as per the applicable standards.

⁄ The plumbing codes applicable in the respective

countries must be observed.

⁄ During installation of the product by qualified trained

personnel, make sure that the entire fastening surface is

even and smooth (no protruding seams or tile offset),

that the finish of the wall is suitable to apply the product

and has no weak points.

T E C H N I C A L D A T A

Operating pressure:

Recommended operating pressure

35284XX7 / 35306XX7:

35300XX7 / 35314XX7:

Hot water temperature:

Thermal disinfection:

The product is exclusively designed for drinking water!

F A U L T

⁄ Head shower extremely leaky

⁄ Shower drips continuously

⁄ Water drips from showerhead a short

time after the valve is closed

⁄ Sprays not operating properly

A S S E M B L Y (see page 04)

max. 0,6 MPa

0,28 - 0,4 MPa

0,2 - 0,4 MPa

(1 MPa = 10 bar = 147 PSI)

max. 60°C

70°C ⁄ 4 min

C A U S E

⁄ Head shower soiled ⁄ scaled

⁄ Shut-off unit damaged

⁄ Normal clearing of pipes

⁄ Flow pressure too low

⁄ Filters are dirty

⁄ Head shower soiled ⁄ scaled

S Y M B O L D E S C R I P T I O N

Do not use silicone containing acetic acid!

D I M E N S I O N S (see page 08)

F L O W D I A G R A M

(see page 10)

C L E A N I N G (see page 12)

S P A R E P A R T S (see page 11)

O P E R A T I O N (see page 11)

R E M E D Y

⁄ Clean ⁄ descale head shower

(see page 12)

⁄ Exchange shut-off unit

⁄ Check water pressure (If a pump has

been installed check to see if the

pump is working).

⁄ Increase water pressure

⁄ Clean filters (see page 14)

⁄ Clean ⁄ descale head shower

(see page 12)

0 3