Accurex Temperature Interlock Panduan Pemasangan, Pengoperasian, dan Pemeliharaan - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemasangan, Pengoperasian, dan Pemeliharaan untuk Pengontrol Accurex Temperature Interlock. Accurex Temperature Interlock 12 halaman.

Halaman Cetak
Receiving and Unpacking
Receiving
Upon receiving the product, check to make sure all
items are accounted for by referencing the bill of lading
or packing list to ensure all items were received. Notify
the carrier if any damage is noticed. The carrier will
make notification on the delivery receipt acknowledging
any damage to the product. All damage should be
noted on all of the copies of the bill of lading which is
countersigned by the delivering carrier. If damaged upon
arrival, file a claim with the carrier. Any physical damage
to the unit after acceptance is not the responsibility of
the manufacturer.
Unpacking
Verify that all required parts and the correct quantity of
each item have been received. If any items are missing,
report shortages to your local representative to arrange
for obtaining missing parts.
Storage
If a temperature interlock must be stored prior to
installation, it must be protected from dirt and moisture.
Indoor storage is highly recommended.
NOTE
Improper storage which results in damage to the unit
will void the warranty.
Handling
Make sure the equipment does not suffer any heavy
vibration or knocks.
Installation
Control Box Mounting
NOTE
Control box may be factory mounted. If so, continue
to the next section.
Locate an area with enough space to mount the control
box and fasten to the wall. Avoid installing the control
box in environments with high magnetic and/or radio
frequency interference.

Thermostat(s) - Hood Mounting

NOTE
Thermostat sensor(s) may be factory installed. If so,
continue to the next section.
1. Locate the flat area(s) at the top interior of the hood
in front of the filters, towards the front of the hood.
19.525 inches
(495.9 mm)
Exhaust Area
Sensor Install
(cut out area)
Supply Area
(optional)
Hood Plan View
2. Find a suitable
location for the sensor
in the flat space that
will not interfere with
the fire suppression nozzles
and that is not within
(304.8 mm)
12 inches
any light fixtures. Cut a 1
(28.6 to 31.8 mm)
to 1¼ inch
diameter hole in the flat spot of the capture tank.
3. Place the J-box plate inside the octagon extension
ring and place over the hole.
4. Disassemble the compression seal and place
through hole and J-box plate as shown. Tighten the
nut inside the octagon extension ring.
Compression Seal
PN 452614
Gasket
Exploded View (Components)
3 inch air space
(76.2 mm)
2 inch typical
(50.8 mm)
(28.6 to 31.8 mm)
of
1
⁄
8
Hood Surface
Octagon Extension
PN 830125
Junction Box Plate
PN 732396
Lock Washer
Nut
Temperature Interlock
3